Backtrack Wireless: Packet Sniffing and Injecting

Packet Sniffing and Packet Injecting

WLAN Frames:

1. Management frames: Management frames are responsible for maintaining
   communication between the access points and wireless clients.
2. Control frames: Control frames are responsible for ensuring a proper exchange of
   data between the access point and wireless clients.
3. Data frames: Data frames carry the actual data sent on the wireless network. There
   are no sub-types for data frames.

Packet Sniffing with Wireshark

Open wireshark by navigating the application menu or by typing “wireshark” in the console.

Once WireShark is open, Click Interface List (1). A second window will open with a list of interfaces that can capture packets. Notice our monitor device mon0 is there from when we set it earlier. Click on start (2) and WireShark will begin to capture packets and display them in the window. These are wireless packets which your wireless card (in my case the Alfa One Adapter), are sniffing out of the air.

Now lets sniff packets from our own access point. To do this, we are going to use airodump-ng. Airodump-ng is used to capture wireless packets which have WEP encryption with the idea that you will use aircrack-ng (don’t worry, we’ll get to that soon). But for this time around, lets turn off the encryption on our wireless access point.

Now open up the terminal and type:
airodump-ng --bssid 5C:D9:98:6A:64:8A mon0

Note: 5C:D9:98:6A:64:8A is the MAC address of my wireless access point. To find yours, go to your wireless routerweb interface and look for status. There you should find the wireless mac address of your router.

After airodump-ng finishes, you will see your access point with the channel it is running on.

Now we have to lock on to our access point by setting our wireless card to the channel of our access point. To do this, type:

iwconfig mon0 channel 6
(Where “6″ is the channel of your access point.)

Now fire up wireshark, sniff for packet with your mon0 interface. Now type in the filter box:

(wlan.bssid == MAC ADDRESS HERE) && (wlan.fc.type_subtype == 0×20)

Now we will be sniffing only data packets from our access point.

Packet Injecting

First we want to see only non-beacon packets in wireshark. So open wireshark and type in your filter box:

bssid == 5C:D9:98:6A:64:8A) && !(wlan.fc.type_subtype == 0×08).

Note: Replace 5C:D9:98:6A:64:8A with your own mac address.

Then open the terminal and type:

aireplay-ng -9 -e "Hack Lab" -a 5C:D9:98:6A:64:8A mon0

Note: Replace Hack Lab with the name of your SSID and 5C:D9:98:6A:64:8A with your own mac address.

If you go back to wireshark, you should see some packets that were injected. These are just random packets that do not have any real effect.